Chiller Cooling Tower Diagram The chilled water enters the ahu fcu and passes through the cooling coil (a series of thin pipes) where it will absorb the heat of the air blowing across. the chilled water heats up and the air blowing across it cools down. when the chilled water leaves the cooling coil it will now be warmer at around 12°c (53.6°f). Condenser water return pipework [1] the cooling tower return pipework is installed to transport the warm water from the condenser side of the water cooled chiller to the cooling tower, with the flow being provided by the condenser water pumps that are installed on the supply side of the tower [tower to chiller] to move the water around the system.
How Do Cooling Towers Work Sequence of operation. when the operating fan(s) are operating at 50 percent speed, an additional fan shall be enabled and controlled at the same speed as the operating fans until all active cooling tower cell fans are enabled. when operating fans are running at minimum speed and the tower supply water temperature is five (5) degrees below the. The cooling system diagram for an absorption chiller typically includes an evaporator, condenser, absorber, generator, and pump. in this type of chiller, heat is used to drive the absorption process, allowing for efficient cooling without the need for a compressor. whatever the type of chiller, understanding the cooling system diagram is. How chillers and cooling towers work together. the system works on vapor absorption cycle which employs a refrigerating fluid as working agent that removes heat from the building. compressed fluid from compressor demands a reduction of its heat energy before expanding to cause cooling. The chiller adds heat to the condenser water and the cooling tower cools it down by rejecting this into the atmosphere. the heat it rejects is all the unwanted heat from the building caused by the people, computers, sunlight, lighting etc. it must also reject the heat generated by the compressor of the chiller.
Comments are closed.