Ford Mustang Gt 2005 To 2014 How To Replace Thermostat Reconnect all radiator hoses and the thermostat sensor electrical connection if you removed them. re install the three bolts that hold the upper thermostat housing section to the lower. re install the four bolts that hold the intake valve to the engine block. re install the intake tube and tighten both band clamps. Step 5 – remove the thermostat cover. there are three 8mm bolts that hold the thermostat cover in place. the use of the swivel 8mm socket makes this job much easier. remove the three bolts and pull the cover off. you should now see the thermostat sitting in the lower housing unit. figure 7.
Ford Mustang Gt 2005 2014 How To Replace Thermostat Mustangforums Drain the radiator. remove the upper radiator hose. if the upper and lower hoses are original consider changeing both of these and the heater hoses as well. the thermostat housing is held in place by two bolts. use a 1 2 inch wrench. one of the bolts is easy to get at and the other will try your patience!. Slide the radiator into place in the engine bay. re install the four bolts that hold on the a c condenser. tighten to 89 ft lbs. reconnect the fan electrical connection. reattach the lower, upper, and overflow radiator hoses. reinstall the two radiator brackets to the core support and install the two bolts on both sides. Step 4 after locating the thermostat housing, use a channel lock to unclip the hose clamp. when you remove the hose, make sure and keep it tilted upright so that you don't leak any antifreeze. the second image shows how you should do this. Step 11 – replace fluids. make sure that the drain plug is completely installed from the lower left side of the radiator. remove the radiator cap and insert a large capacity no spill funnel. fill the radiator with a 50:50 premix solution, or use distilled water only if mixing your own.
Ford Mustang Gt 2005 To 2014 How To Replace Thermostat Step 4 after locating the thermostat housing, use a channel lock to unclip the hose clamp. when you remove the hose, make sure and keep it tilted upright so that you don't leak any antifreeze. the second image shows how you should do this. Step 11 – replace fluids. make sure that the drain plug is completely installed from the lower left side of the radiator. remove the radiator cap and insert a large capacity no spill funnel. fill the radiator with a 50:50 premix solution, or use distilled water only if mixing your own. Do this by locating the c clamps on the throttle body and airbox. loosen the c clamp nuts with a flathead screwdriver. disconnect the breather tube feeding into the passenger side of the intake tube by pressing on the green ring and pulling gently. disconnect the maf sensor plug from the air tube as well. once the clamps are loosened and the. This video demonstrates how to remove and replace your coolant thermostat gasket. if you want to replace your coolant thermostat as well, this video shows yo.
Comments are closed.