Hikvision Latest Version Nvr Ip Camera Poe Switch Co Latest version nvr and ip camera connection, intial nvr setup, hard disk installation & hik connect mobile app configuration explained by step by step.*****. Nvr by default routes traffic between the subnet it is connected to and the camera poe subnet. step1: for each camera set nvr poe ip (192.168.254.1) as a default gateway. step2: on your desktop add a static route for the poe subnet, using this command: route add net 192.168.254.0 netmask 255.255.255.0 gw <nvr ip address>.
Hikvision Latest Version Nvr Ip Camera Poe Switch Co Navigate to configuration > network > advanced settings and select the other tab. here you have to tick the enable virtual host box. step 4. go to configuration > system > camera management and on the right side of the screen you’ll see a clickable link for each ip camera connected to the poe nvr. Solution : if the ip camera has hard reset button, please turn off the camera (cut off the power). then keep holding the button for more than 30 seconds. meanwhile, power on the camera while holding the button. the device would be back to the inactive status. poe nvr will automatically active and connect the camera. The poe connected cameras need to have their default gateway set to the ip address of the nvr poe interface, usually 192.168.254.1 how it's done varies with the specific brand and model of the router. this is as good a description of the required settings as any, assuming the nvr poe interface ip address is 192.168.254.1 :. Hikvision latest version 16ch nvr (ds 7p16n1 k2) with 4mp ip camera and poe switch on site installation by green tech solutions4ch nvr hikvision 6999.
Comments are closed.