Your Pathway to Success

How To Attach Ledger Board For A Deck Decks

how To Attach Ledger Board For A Deck Decks
how To Attach Ledger Board For A Deck Decks

How To Attach Ledger Board For A Deck Decks Measure siding for a cutout. 6. after properly installing the flashing, install the siding above the ledger as needed. make sure the bottom of the siding will be at the desired height in relation to the decking. in our case, we want the bottom of the siding to be 1 4 inch above the decking, which will be 1 inch thick. 1 2" lag screws. this is a side view of the perspective diagram above. it is one of the most common ways of connecting the ledger to the band board. in this instance, minimum 1 2" lags are staggered along the length of the board. the lags should pass through by at least 1 2" on the back side of the band board.

how To Attach Ledger Board For A Deck Decks
how To Attach Ledger Board For A Deck Decks

How To Attach Ledger Board For A Deck Decks Sloping the deck, caulking the vulnerable joints, and flashing properly should prevent water from getting in at the ledger board. felt paper above the ledger directs any water that has made its way behind the siding to the 2×2 flashing and out. and if water somehow does make it behind the ledger, there’s another layer of paper to protect the. To attach a ledger against a wall through brick veneer: mark anchor locations on your ledger and drill through the board with a ½” bit. position the ledger against the wall and mark the anchor positions through the hole onto the wall. drill through the brick veneer with a ½ inch masonry bit in a hammer drill, until you reach the wood frame. A deck ledger board is used when attaching a deck to a house. it supports both the deck joists, as well as bolsters the framing of the deck. if your deck is attached to your house (and not a free standing deck), you’ll also need deck flashing, which serves as a barrier against moisture from getting into the house through any openings made while attaching your ledger board. Step 1: attach ledger board with fasteners. place the ledger board on top of the bottom ledger flashing. make sure the top of the ledger board is even with the chalk line snapped earlier. drill the fasteners in through the ledger and into the wall of the house until the head of the fastener is flush with the face of the ledger board.

Comments are closed.