How To Configure And Set Ip Address To Serial Interface Of Cisco Router

How To Configure And Set Ip Address To Serial Interface Of Cisco Router Use the following formula to calculate the maximum number of pvcs supported on a card: (mtu 13) 8 = maximum number of pvcs. note the default setting of the mtu command for a serial interface is 1504 bytes. therefore, the default numbers of pvcs supported on a serial interface configured with cisco lmi is 186. Cisco serial interface configuration, serial interface cisco examplehow to configure serial interfaces in cisco routers? in this lesson, we will learn cisco.

How To Configure Cisco Router Interfaces Fastethernet And Serial R2#show interface serial 0 0 serial0 0 is up, line protocol is up hardware is powerquicc serial description: link to r1 internet address is 192.168.1.2 30 mtu 1500 bytes, bw 1544 kbit, dly 20000 usec, reliability 255 255, txload 1 255, rxload 1 255 encapsulation hdlc, loopback not set keepalive set (10 sec) last input 00:00:09, output 00:00:10. Rp 0 rsp0 cpu0:router# show interface serial 0 1 0 0 wed oct 8 04:14:39.946 pst dst serial0 1 0 0 is up, line protocol is up interface state transitions: 5 hardware is serial network interface(s) internet address is 10.20.3.1 24 mtu 4474 bytes, bw 44210 kbit reliability 255 255, txload 0 255, rxload 0 255 encapsulation frame relay, crc 16. Router(config)#interface serial 0 0 0 : enter into serial interface 0 0 0 configuration mode: router(config if)#description connected to bhilwara: optional command. it set description on interface that is locally significant: router(config if)#ip address 10.0.0.1 255.0.0.0: assigns address and subnet mask to interface: router(config if)#clock. Configuring ip address. ip addresses are the building block to ip communications. in a router, any active ip interface will require an ip address. setting the ip address includes setting of the address itself plus the mask. the mask tells the router how to read the ip address and understand in terms of networks and hosts.

How To Configure Cisco Router Interfaces Fastethernet And Serial Router(config)#interface serial 0 0 0 : enter into serial interface 0 0 0 configuration mode: router(config if)#description connected to bhilwara: optional command. it set description on interface that is locally significant: router(config if)#ip address 10.0.0.1 255.0.0.0: assigns address and subnet mask to interface: router(config if)#clock. Configuring ip address. ip addresses are the building block to ip communications. in a router, any active ip interface will require an ip address. setting the ip address includes setting of the address itself plus the mask. the mask tells the router how to read the ip address and understand in terms of networks and hosts. The loopback interface in this sample configuration is used to support network address translation (nat) on the virtual template interface. this configuration example shows the loopback interface configured on the gigabit ethernet interface with an ip address of 200.200.100.1 24, which acts as a static ip address. The first step is to secure your access to the router by configuring a global secret password and also passwords for telnet or console as needed. enter into global configuration mode from the privileged exec mode: router# configure terminal <– privileged exec mode. router (config)# <– global configuration mode.