How To Install Deck Joists Diy Deck Plans Mark the ledger every 16 inches. starting at the left side of your deck, position one 2x8 joist hanger at each mark, so that they are plumb, and the inside of the bracket bottom is level with the bottom edge of the ledger. drive screws through every hole in the left side of the hanger to attach it firmly. leave the right side loose. In this video i will show you how to build a deck. i specifically show you how to install deck floor joists and joist hangers using 2x10 pressure treated lum.
How To Build A Simple Deck Using Joist Hangers Assemble the outside frame as you did when you laid out the deck, set it on the beams, and attach the rim joists to the ledger. check for square, then anchor the rim joists to the beam with screws. to mark the angled cut line, measure out from the corner an equal distance in both directions. align a straight 1x4 with both measurements, and mark. Or you can install all the joists, snap a chalk line across the top of the joist where the block will go. then cut the block and install them ahead and behind the line. this will make fastening easier. if installing the blocking after, wait till the rim joist is installed as this will make them more stable to work off. Double check your joist spacing at each joint. it should be 16” oc. use the same sized spacers to check this that you used when laying out the joists. toe nail the joists to the support beams at each point that those two systems intersect. this will help stiffen the frame. use 3 inch nails, or screws. If you are using shadoe® track, install the joist cap prior to shadoe® track installation. track is then hand nailed through the cap using galvanized nails. hand nailing is the best method for accurate installation versus using a nail gun, which frequently causes misalignment. when decking is to be angled, install sections of shadoe® track.
Comments are closed.