Build A Fence Setting Fence Posts Plumb And Perfect Tools And Tips This is how we set and plumb posts on a wood fence. we used pressure treated lumber for 4x4s. this is how mr. fence builds our wood fences.we are mr. fence!. Push the strings outward, toward the heads of the nails, to create a string guide that’s 1 8 inch away from the posts. to set the subsequent posts, position each post in its hole, keeping it 1 8.
How To Set And Plumb Level Fence Posts Wood Fence Youtube To set a post in gravel or soil, tamp down a 2 3 inch (5 8 cm) layer of gravel and insert the post. then, add and tamp gravel or soil into the hole until it’s filled. to set a post in concrete, tamp down a 4 6 inch (10 15 cm) layer of gravel and insert the post. brace it with stakes, then shovel concrete into the hole. Check the post for plumb, again, to make sure the wood post didn’t move while you were fastening the fence post to the scrap wood. next step is mixing the concrete. follow the directions on the package. carefully pour the concrete into the hole around the post. wait until the concrete is cured before removing the scrap pieces of lumber. Add a few inches of gravel to the bottom of each hole to improve drainage and provide a stable base. place the fence post in the hole, ensuring it is plumb with a level. fill the hole with concrete, leveling the post as you go. use a trowel to slope the concrete away from the post to prevent water from pooling around it. Step 1: create guides for the picket tops. to help keep the tops of the pickets even, attach furring strips to the posts and tie mason line between them at the desired height. if the stringers slope with the ground, the guide string will as well. use the line as a guide for the tops of the pickets.
Build A Fence Setting Fence Posts Plumb And Perfect Tools And Tips Add a few inches of gravel to the bottom of each hole to improve drainage and provide a stable base. place the fence post in the hole, ensuring it is plumb with a level. fill the hole with concrete, leveling the post as you go. use a trowel to slope the concrete away from the post to prevent water from pooling around it. Step 1: create guides for the picket tops. to help keep the tops of the pickets even, attach furring strips to the posts and tie mason line between them at the desired height. if the stringers slope with the ground, the guide string will as well. use the line as a guide for the tops of the pickets. Dig the hole to be a little bit bigger than the fence post. if you are going to surround the post in concrete or gravel leave a little extra room to fill it in. concrete usually requires a larger hole roughly 12 inches wide for a 4×4 post while gravel can be roughly 8 inches wide for a 4×4 post. next, take your fence post and stick it in the. Add water and use a shovel to mix the concrete solution (use the formula mentioned above to calculate the amount of water needed). use a shovel to pour the concrete into the hole. use a trowel to smooth the surface and slope it away from the post. fast set concrete dries in about 30 minutes, so work quickly.
Comments are closed.