Basic Home Theater Av Set Up Guide Hooking It All Up Audioholics How to put the connectors on your speaker wires. split the wire down the center. trim insulation from the wire ends. attach the connectors, as shown in the video below. make sure you match the colors on the connectors (usually black and red) to the colors or markings on each side of your speaker wire. To set up multi zone audio: connect additional speakers to your receiver’s dedicated multi zone speaker terminals, usually labeled as “zone 2” or “zone 3.”. if your receiver has powered zone outputs, connect the speakers directly. if not, use a separate amplifier for each additional zone.
How To Set Up Your Home Theater Receiver In 2019 Outdoor Movie How to set up a home theater receiver . connect any antennas that came with the receiver (am fm, bluetooth, wi fi). if the home theater receiver doesn't have built in wi fi, or you don't want to use it, you may have the option of connecting an ethernet cable directly to the receiver's ethernet lan port. This is to allow the heat generated by the amplifiers to dissipate, an important function for any amp to run cleanly and safely. if you cram your receiver into a tight shelf space, there’s no place for this heat to go. too much heat build up, and your receiver can shut down. ideally, you should leave at least three inches of space above the. Set the tip of the microphone at the point between where your ears would be if you were sitting in the center seat. aim it up towards your ceiling. play the test tones through each speaker one at a time, and set the level of each speaker so that it reads approximately 75db on the meter. Hook input devices. ensure you’re using the correct cables when connecting your input devices, such as your tv, game console, set top box, and blu ray player. also, remember to connect each device to the corresponding input on the receiver to avoid compatibility issues. finally, use a universal remote to simplify your experience if you have.
Comments are closed.