Planning Your Next Custom Water Cooling Loop Titan Rig Blog Reservoir – standalone or combination unit. pump – if it’s not part of the reservoir. radiators – as much space as you need for cooling your heat loads, and in whichever type you decided on. tube fittings – for the fittings that actually connect to your tube, make sure they’re the right type and size. A water cooling loop follows the same principle an air cooler does: it takes heat from a hardware (e.g., a cpu die) and dissipates it into the air. any loop consists of the following nodes: pump.
How To Build A Water Cooled Gaming Pc Custom Loop Simple custom loop. this handy graphic breaks down the liquid cooling loop into its simplest form. starting at the bottom and moving clockwise, you’ll see that the reservoir feeds into the pump which then flows into the water block (s) followed by the radiator for exchanging heat with the surrounding air before finally completing the loop. The liquid cooling market provides three diameters of soft tubing that are the most common. tubes are marked with id and od which stand for „inner diameter“ and „outer diameter“. there are two ways to mark the fittings, one is using metric millimeters (mm) and the other is using imperial inches (“). these three most common tubes are. Custom test rig with a fully custom watercooling loop by ppsu. pc watercooling or as it is also known, liquid pc cooling, is a form of extreme pc cooling which come about because of pc enthusiasts and pc gamers constant need for more processing speed and frame rates. liquid cooling loops consist of a pump, radiator, watercooling block and hard or soft tubing. That indicates the loop is filled. if you get water liquid all over the place, the parts need to be taken out (meaning mobo, gpu, etc), rinsed in alcohol, lightly scrubbed with a toothbrush, compressed air and if possible blow dried very, very well on low heat, then left to dry for at least 24 hours.
Comments are closed.