Implement Rip On Packet Tracer For A Network Topology With Three Cisco It is a distance vector routing protocol that has an ad value of 120 and works on the network layer of the osi model. steps to configure and verify three router connections in cisco packet tracer using rip routing: step 1: first, open the cisco packet tracer desktop and select the devices given below: s.no. device. model name. This tutorial explains how to configure rip routing protocol step by step in detail. rip is the simplest and one of the oldest distance vector routing protocol. learn how to enable and configure rip routing in cisco router with practical example in packet tracer.
Rip Routing Configuration Using 3 Routers In Cisco Packet Tracer Rip routing configuration lab using three routers in cisco packet tracer in this tutorial we will learn how to configure rip routing using three routers.this rip routing configuration lab is done with the help of cisco packet tracer.if you are learning ccna or getting prepared for ccna certification exam then this tutorial will be beneficial…. The number of routers used for this rip routing lab are three.i have shown ripv2 configuration using cisco packet tracer.and i have also shown how to check which routing protocol is configured on a router if you are new to the company. The imlementation of this lab involves entering the below codes on all three routers, starting from router0. you may also like: how to implement eigrp on a network topology with three cisco routers. router0. router>en. router#conf t. router (config)#hostname router0. router0 (config)#int s0 3 0. 1. configuring gigabitethernet and serial ports. step 1. click on the r1 router you made in the setup, and open the settings. after that, go to the cli tab. use the commands below to give ip addresses to r1’s gigabitethernet and serial ports. for r1 – se0 1 0: r1#conf t. r1(config)#interface serial 0 1 0.
Rip Routing Configuration Using 3 Routers In Cisco Packet Tracer The imlementation of this lab involves entering the below codes on all three routers, starting from router0. you may also like: how to implement eigrp on a network topology with three cisco routers. router0. router>en. router#conf t. router (config)#hostname router0. router0 (config)#int s0 3 0. 1. configuring gigabitethernet and serial ports. step 1. click on the r1 router you made in the setup, and open the settings. after that, go to the cli tab. use the commands below to give ip addresses to r1’s gigabitethernet and serial ports. for r1 – se0 1 0: r1#conf t. r1(config)#interface serial 0 1 0. Configure rip in three simple steps. 1. assign ip address to the router interfaces. 2. user version 2 command to use rip v2. 3. finally use network command to advertise the networks. check the example below in which we have configured the rip protocol on three connected routers. the static routing is not feasible in a large network. Task 5: verify rip routing. step 1. use the show ip route command to verify that each router has all of the networks in the topology entered in the routing table. step 2. use the show ip protocols command to view information about the routing processes. step 3. use the debug ip rip command to view the rip messages being sent and received. step 4.
Comments are closed.