Toyota Hilux Vigo Rear Axle Bearing Removal Using Basic Tools Youtube How to disassemble toyota hilux vigo rear brake, bearing and axle assemblylikely the same for other toyotas with drum brakes such as the hiace surfif you. How to replace n70 kun26 2005 2015 toyota hilux rear wheel bearings and reseal to fix leaksa complete how to guide on disassembly and assembly including pull.
Toyota Hilux Vigo Rear Axle Bearing Removal Using ођ How to put hilux vigo rear axle bearing back together including changing the studsif you are buying bearings or a shaft be aware the shaft changes and ther. 9.remove the 4 14mm nuts that hold the axle shaft to the housing. 10.loosen the brake line. use a paper towel under it to catch spills for now. 11.pull the axle shaft out and set it aside. 12.put a vacuum cap or something over the end of the brake line to prevent spillage. 13.remove the rear speed sensor. Test brg fit in axle housing to be sure the housing hasn't worn. new brg need a rubber seal on outer side only, the inner one can be pulled off to allow oil into brg. clean axle housing on loose side to remove any grit which may have got in. clean all parts [except brgs] before reassembly. For what its worth, here's a few dimensions: overall length from bottom of plate to top of tube is 19.375". the plate is 6" x 6" x 3 8". i cut a 2" hole in the center, and then the 4x hole pattern for the axle studs. the axle stud holes are .433" dia, and spaced 3.486" apart (symmetrically around the 2" bore).
Comments are closed.